CALIBRATION & MAINTENANCE
Standards You Can Trust
CALIBRATION & MAINTENANCE
Calibration and maintenance are essential practices in preserving maximum productivity and reliability in your production process. When carried out as part of a planned schedule, our service helps you to reduce downtime and to enhance quality and safety compliance
- Improve efficiency and increase reliability
- Prevent faults and minimise production downtime
- Boost confidence in your production process
- Enjoy higher quality outputs
- Strengthen regulatory compliance.
If the readings are outside specified tolerances, our technicians adjust the unit under test accordingly. They then issue a calibration certificate using our ProCalV5 calibration management software which captures the calibration results. Recommended maintenance procedures or actions to address underperforming or out-of-tolerance equipment are also recorded in an electronic service report. The report is linked through ProCalV5 directly to the instrument under test for any necessary future analysis.
We add value to our service by providing experienced Instrumentation and Control Technicians. This means we can offer advice and fault-finding expertise on site, so you can get the most out of your calibrations.
Similarly, our maintenance offering goes beyond the traditional model. In addition to our scheduled and on-demand maintenance service for routine or emergency situations, we also provide preventative maintenance advice and forward planning as part of our Instrumentation Analysis service.
Our maintenance work is primarily focused on fault-finding. If you experience a breakdown on your plant, we send out a technician who diagnoses the problem and recommends an appropriate solution. Be it a replacement, repair or recalibration, we’ve got you covered with our extensive range of services. We also supply routine scheduled maintenance to ensure your instrumentation is operating at peak performance all year round.
Calibration and maintenance services can be delivered both on or off site – whichever suits you best. Our In-house Technician can look after any requirements you may have in our fully equipped laboratory at our Dublin headquarters. From here, we can also pre-calibrate new instrumentation prior to despatch as part of our Procurement & Supply service.
Bonner Calibration Services Brochure
Contact Us Now
35 Western Parkway Business Centre
Ballymount Drive, Dublin 12
D12 X542, Ireland
33a Mitchelstown Enterprise Centre Mitchelstown, Co. Cork
P67 X660, Ireland
T +353 450 5050